If you see the message “Measuring is not possible in Standby State” in Trackman Performance Studio (TPS), it means the system is not actively tracking because it is in a low-power or idle mode. This article explains what causes this error and how to solve it.
Overview of the Error
- Standby State: This is a power-saving mode where the Trackman radar is not actively measuring data.
- Measuring: Refers to the radar’s ability to track ball and club movement during a session.
When the system is in standby, it cannot collect or display tracking data.
The common causes of the error is:
- No Active Session: TPS may not be in a live session mode.
- Radar Not Activated: The radar unit may not be turned on or connected properly.
- Software Idle: TPS has been idle for too long and entered standby automatically.
- Incorrect Setup: Calibration or session setup may be incomplete.
- Instant Ready Mode enabled.
Fixing the Error
- Navigate to the TM4 Web Interface
- Look for the "Instant Ready Mode" and make sure this is checked OFF
- Instant Ready Mode is only supported outdoors. In indoor, this function will not give you any use.
- Save changes.